Florida Mechanical Contractor Contractor Exam Book Set
These books are valid for testing after July 2021
The Florida Mechanical Contractor Exam is an open book test that requires 18 books for the exam. This book package includes all of the required references for your trade exam:
- Air Conditioning and Refrigeration Troubleshooting Handbook, Billy Langley, 2nd Edition, 2003
- Code of Federal Regulations, (OSHA) 29 Part 1926 July 2020
- Contractors Manual, 2017
- Pipefitters Handbook, Forrest R. Lindsey, 3rd Edition, 1967
- NFPA 90A Installation of Air Conditioning and Ventilating Systems, 2015
- NFPA 90B Installation of Warm Air Heating and Air Conditioning Systems, 2018
- NFPA 96 Standard for Ventilation Control and Fire Protection of Commercial Cooking Operations, 2017
- NFPA 99 - Health Care Facilities, (Chapter 3 & 5, Annex A & C), 2018.
- Fibrous Glass Duct Construction Standards, 7th Edition, 2003
- HVAC Duct Construction Standards, Metal and Flexible, 3rd Edition 2005
- Energy Systems Analysis and Management, 2nd Edition, 2014
- Trane Air Conditioning Manual, 6th Edition. (70th, 71st, 72nd, 73rd printing with errata through 6/03 or 74th printing)
- Trane Ductulator, 1976 or later
- Trane Reciprocating Refrigeration Manual, 67th Printing, Rev. March 1999
- Energy Efficient Building Construction in Florida, 9th Ed., 2020
- Florida Building Code - Mechanical, 2020
- Florida Building Code - Energy Conservation, 2020
- Florida Building Code – Fuel Gas, 2020
This book package is for the Florida Mechanical Contractor Exam. If you need to take the Business and Finance Exam, you can buy these books HERE.
Florida Mechanical Contractor is a contractor whose services are unlimited in the execution of contracts requiring the experience, knowledge, and skill to install, maintain, repair, fabricate, alter, extend, or design, if not prohibited by law, central air-conditioning, refrigeration, heating, and ventilating systems, including duct work in connection with a complete system if such duct work is performed by the contractor as necessary to complete an air-distribution system, boiler and unfired pressure vessel systems, lift station equipment and piping, and all appurtenances, apparatus, or equipment used in connection therewith, and any duct cleaning and equipment sanitizing that requires at least a partial disassembling of the system; to install, maintain, repair, fabricate, alter, extend, or design, if not prohibited by law, piping, insulation of pipes, vessels and ducts, pressure and process piping, pneumatic control piping, gasoline tanks and pump installations and piping for same, standpipes, air piping, vacuum line piping, oxygen lines, nitrous oxide piping, ink and chemical lines, fuel transmission lines, liquefied petroleum gas lines within buildings, and natural gas fuel lines within buildings; to replace, disconnect, or reconnect power wiring on the load side of the dedicated existing electrical disconnect switch; to install, disconnect, and reconnect low voltage heating, ventilating, and air-conditioning control wiring; and to install a condensate drain from an air-conditioning unit to an existing safe waste or other approved disposal other than a direct connection to a sanitary system. The scope of work for such contractor also includes any excavation work incidental thereto, but does not include any work such as potable water lines or connections thereto, sanitary sewer lines, swimming pool piping, and filters, or electrical power wiring.
A Florida Mechanical Contractor may test and evaluate central air-conditioning, refrigeration, heating, and ventilating systems, including duct work; however, a mandatory licensing requirement is not established for the performance of these specific services.
DID YOU KNOW? Every time you fail the exam, you must pay the State of Florida $135 + $80 to Pearson Vue per exam.
Statistics for Mechanical Contractor Exam 2019:
- 44% Passed
- 56% Failed
GAIN THE SKILLS YOU NEED TO PASS THE EXAM THE FIRST TIME WITH OUR ONLINE HOME STUDY COURSES!
Our Florida Mechanical Contractor Exam Prep Course is designed by contractors, for contractors. We provide the most effective training available to prepare you for the Florida Mechanical Contractor Exam and make sure you don't have to take the exam a second or third time!